Hi there, please find instructions below to install PlusDesignBuild
1) Please login here with your email address and password. Then click [Download] button
1) Please login here with your email address and password. Then click [Download] button
2) Select your specific system requirements, then download the RBZ, then install it.
There is a video on the page to help you with this. (Note: Please dont try to open the RBZ)
There is a video on the page to help you with this. (Note: Please dont try to open the RBZ)
3) Once the RBZ is installed, if you are automatically signed in you will just need to sign out (as per image 1, 2, 3), then close/re-open SketchUp.
(Skip this step if it is asking you to login with your email address and password).
4) When you re-open SketchUp, you should be presented with the login page. Sign in with your login credentials, press Activate on your subscription that aligns with (type) Pkgelitedesignbuild or PlusDesignBuild (as per image below)
5) Close / Re-open SketchUp.
Wait for everything to load, and if it doesn't automatically do it perform a sync. (let it 100% complete).
6) If you don't see the new tool bar you may need to delete PlusSpec at this article Here and follow the above steps 1 -5 in this article.
Comments
0 comments
Please sign in to leave a comment.